Concrete Contractor in Richmond Hill, GA - Driveways and Patios on Solid Ground
Hinesville Concrete is a concrete contractor from Hinesville, GA, working in Richmond Hill. We build driveways, patios, sidewalks, garage floors and pool decks here, and we get the ground and forms right before anything gets poured.
Richmond Hill: older yards, newer builder slabs
Richmond Hill sits on the Great Ogeechee River just south of Savannah, close enough to our base in Hinesville that we're over here often. On our jobs we see older homes on wide yards next to newer neighborhoods where the builder poured the driveway, the front walk and a small back patio all at once. The calls are usually about a driveway that sank at one corner, a patio that holds water by the back door, or a family that needs room for one more car.
The older lots usually hide old concrete, roots or fill under the slab. On the newer ones, plenty of builder concrete sits on dirt that was spread and raked but never packed, and I don't know which kind I've got until the old slab comes up.
- Fully licensed and insured.
- Free on-site estimates.
- Expect a reply within 1 business day.
Concrete work we do in Richmond Hill
Concrete driveway building
Plenty of driveways here went in fast over loose fill, so they settle and crack. We dig down to firm ground and pack the base before we pour.
Concrete patio construction
Patios added after the house often sit low and hold water at the back door. We set the slope so the slab drains away from your house.
Concrete sidewalk building
Front walks get lifted by roots and turn into trip hazards. We build a concrete sidewalk on packed base, with joints cut in time.
Garage floor concrete
Garage slabs carry trucks and boats, and thin ones crack near the door. We pour them over packed base with rebar, the steel that holds cracks tight.
Concrete pool decks
Pool decks stay wet and see bare feet, so the finish matters. We give them a texture that grips without scraping and slope them so water runs off.
Concrete cutting
When one section of an older driveway sinks, cutting out just that piece can beat a full tear-out. We saw clean edges so the new pour sits flush.
Working in Richmond Hill: permits, prep and price
Inside the City of Richmond Hill, building permits come from the city's Planning & Zoning Department, which also runs the building inspections and takes questions at 912-756-3641. When a job needs a permit, the paperwork and the inspection become part of the schedule, so we apply for it ourselves and keep it moving instead of leaving it on your kitchen table. If I'm not sure what a driveway or patio needs, I ask the department before we start, not after. We're fully licensed and insured.
What moves the price here is mostly what's under the slab. Tearing out old concrete, hauling it off and digging past soft fill to firm ground can cost more than the pour itself, and a stamped or decorative top costs more than a broom finish, the light texture that keeps shoes from slipping. My old boss used to say the pour is the easy part, so when a budget gets tight I'd trim the finish before I'd trim the base, because nobody sees a good base and everybody sees a bad one eventually. The schedule turns on the permit if the job needs one, the weather on pour day and curing, the wait while the concrete gains strength before you walk on it and a longer one before you drive on it. We do the same work out in Glennville and the other cities around Hinesville, and for your own number I'll walk the job and put in writing what we'll do.
Get a free written estimate for your Richmond Hill concrete job
We get back to you within one business day, and there's no obligation. Then I come out to your place in Richmond Hill, look at the job myself and put in writing what we'll do, free of charge. If you go ahead, the crew I trained does the work, and I check the prep and forms before we pour.
- Fully licensed and insured.
- Free on-site estimates.
- Expect a reply within 1 business day.
Concrete ideas for Richmond Hill homes
Concrete questions from Richmond Hill homeowners
Do I need a permit to pour a concrete driveway or patio in Richmond Hill, GA?
The city's permit lists don't settle that for a plain driveway or patio, so I check with Planning & Zoning before we start. New structures, remodels and additions go on the full residential building permit, and the city's smaller-job permit covers things like fences, irrigation, pools and demolition. If your slab needs a permit, we apply for it ourselves.
What building codes apply to concrete work in Richmond Hill?
Richmond Hill follows the Georgia State Minimum Standard Codes, the codes the Georgia Department of Community Affairs adopts, along with Georgia's own amendments. The city has moved to newer editions of those codes, so we build to what's in force now, which can differ from what your house was built under.
How do I request a building inspection in Richmond Hill?
The city takes inspection requests through its CivicGov portal, and without portal access you can call 912-756-4521 or email inspections@richmondhill-ga.gov. Ask at least 24 hours ahead, no later than 4 p.m. on the business day before. When the permit is in our name, keeping up with inspections is part of the paperwork we keep moving.
What do I file to pour concrete myself on my own home in Richmond Hill?
If you do the work yourself on the home you live in, the city also requires you to fill out and submit an Owner Exemption Affidavit on top of the permit application. Planning & Zoning takes questions about which application your job goes on. If you'd rather hand the whole thing off, that's the kind of job we do.
How much does a new concrete driveway cost in Richmond Hill?
A Richmond Hill driveway is priced on its size, the tear-out of any old concrete, the base work under it and the finish on top. A thicker slab with rebar costs more than a thin one, and a lot a concrete truck can't back onto adds labor. I come out, measure it and give you the price in writing.
What causes new concrete driveways in Richmond Hill to crack?
Most cracks in a new driveway come from a base that was never packed, joints cut too late or water running under the slab. Control joints, the shallow cuts across the slab, give concrete a place to crack in a straight line, so we pack the base and cut the joints in time. Concrete still cracks a little, but it should crack in the joint, not across your parking spot.